The Easiest and Strongest pegs you will use.
The Outback Screw peg is designed for those who spend the majority of their time travelling within Australia and away from the Coastal soils, it is designed for areas such as The Far Outback and Centre of Australia. It is designed for the hard red dirt and gravelly surfaces found in these areas.
Ezy Anchor is the product of some 25 years of camping and caravanning across Australia – from Fraser Island to Lawn Hill to Kakadu to Broome to Esperance, Broken Hill and beyond.
After 23 years of setting up and taking down camp in our tents, hard floor camper trailer, hybrid camper and now our caravan, there had to be a better way than driving and pulling pegs.
Installation:
- Use cordless drill or impact driver
- Connect the Torx driver bit to the drill/driver
- Pick up your Ezy Anchor with screw in position through the Ezy Anchor
- Connect your guy rope to the hook
- Hold the guy rope and hook together with your guiding hand
- Pick up the drill and driver in your driving hand
- Insert the Torx driver into the head of the screw
- Place drill in forward drilling position
- Commence drilling the screw downward into the earth keeping the EzyAnchor parallel to the earth so the screw penetrates at its set angle.
- Installation complete
Should you strike a solid object whilst installing the screw, remove and reposition the screw to another position close to or adjacent to the original required position.
Removal:
- With your drill in hand and Torx driver bit connected and secured within your drill chuck connect the Torx bit driver to the screw head.
- Hold the hook and guy rope in one hand, place drill in reverse and screw out.
- Removal complete
In the event of a flat battery you can connect a shifting spanner to the driver bit shaft and unscrew manually to a point where you can remove the screw from the ground.
This is for one peg assembly
